Finally went about the whole case thing. I don't know why exactly, but I'd been avoiding it. The requirements here are that there are 2 cases, one that holds a receiver board, and another that holds a 'cue' board of the 8 contacts. As mentioned in the v0.2 boards post, These are a lot smaller than...

Why the V0.1 Boards were terrible.

So the V0.1 boards had some problems. For one, on the cue boards, I forgot pulldown resistors for the continuity circuits into the input shift registers (what detects if a fuse is plugged in), and also forgot pulldown resistors to the firing signals coming out of...

Buckle up, this will be a long one!

The Struggle-

As part of this whole thing, I really wanted something fairly 'generic', yet good enough at what its supposed to with it's native hardware. Even this far in my building stuff career (professionally and personally), I still find the pull of 'do al...

Once again I have a bit of a lapse in blog posting. I think that'll be the case indefinitely here as the general circumstances that draw me here tend to shift with the seasons. While writing about things may vary, me building things won't, so I guess just expect stuff like this.

Cue Modules are c